Same Subnet Checker

Will your laptop talk to the camera directly? Enter both addresses and masks. Each side is checked with its own mask, so mismatched settings show up instead of hiding behind a yes.

Free forever All calculations happen in your browser. The IPv4 addresses you enter stay on this page and are never sent to our server.

Laptop

Shown by ipconfig as IPv4 Address.

Shown by ipconfig as Subnet Mask, or a prefix like /24.

Camera or other device

From the device label, manual, or its configuration tool.

A prefix like /24, or a mask like 255.255.255.0.

Examples

This calculator needs JavaScript, which is turned off in your browser. When it runs, the math happens on this page and nothing is sent anywhere.

How the check works

Each side decides on its own whether the other is local.

Before sending a packet, a device applies its own mask to the destination. If the destination lands inside its local range, it sends directly over the cable. If not, it hands the packet to its default gateway. So the laptop decides using the laptop’s mask, and the camera decides using the camera’s mask.

Take a laptop at 192.168.1.50/24 and a camera at 192.168.0.108/24. The laptop’s range is 192.168.1.0–192.168.1.255, and the camera isn’t in it. They’re on different subnets, even though the addresses look alike.

Give the laptop 192.168.1.50/16 instead and it now treats the camera as local, but the camera still doesn’t treat the laptop as local. The camera’s replies go to a gateway, so the link isn’t reliable. The checker calls that asymmetric.

Need the full range for one address? Use the Subnet Calculator.

Questions

Does “Same subnet” mean the camera will respond?

No. It means the numbers allow a direct connection. The cable, switch, VLAN, firewall, and the device itself still have to cooperate. Test with ping or the device’s own software.

Is the example address safe to use?

It’s arithmetic only: a usable address in the device’s range that isn’t the device’s address. This page can’t see which addresses are taken, so check that nothing else on the network already uses it.

What if the masks differ but both sides are on-link?

A direct conversation often works, but the two sides disagree about where the network ends, which causes trouble with other hosts and broadcasts. Use the mask the site documents on both.

Does this page contact my camera or change my adapter?

No. It only compares the numbers you type. It doesn’t ping, scan, or change any setting, and it doesn’t talk to the IP Flip app.